If you discover the location of the leak, the following steps indicate how to fix each one. The bottom of the tube is open, and you should check there for wetness as well. The TPR valve is located on the side of the tank, and it should have a copper tube that extends out a few inches and then turns downward to the floor. around the temperature and pressure relief (TPR) valve.the drain valve near the bottom of the tank (the one with the standard garden hose connection), and.the fittings on the pipes above the water heater,.Check for wetness by running your fingers or a tissue around these three likely locations: Water heater leaks often start out slow, just drip by drip, so it can be difficult to tell where the water is coming from. RELATED: 10 Plumbing Tips Everyone Needs to Know Do some sleuthing to find the water heater’s leak. Only the cold pipe will have a shutoff valve turn that valve to the Off position to stop cold water from flowing into the tank. One is the hot water pipe that supplies hot water to your faucets and the other is the cold water supply line. You’ll find two plumbing pipes attached to the top of the water heater. Next, shut off the water pressure to the tank. If it’s an electric water heater, locate your home’s electric service panel, and turn off the breaker labeled “Hot Water Heater” by switching it to the “Off” position. If it’s a gas water heater, it will have a dial or an On/Off switch near the spot where the gas line connects. Turn off the power to the leaking water heater.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |